Plywood & Cabinet Calculators

Yes. The calculator includes a waste allowance because real projects lose material through cut layout, trimming, grain direction, offcuts, damaged edges, and possible cutting mistakes. Use the result as a planning quantity rather than a perfect-world material yield.

You can calculate with standard 4×8 sheets, 5×5 sheets, 5×10 sheets, and custom sheet dimensions. Custom sizing is useful for panels such as 49×98 Baltic Birch and other non-standard sheet formats.

The Sheet Calculator estimates overall sheet quantity using project dimensions. The Cabinet Box Estimator breaks the project into cabinet components such as sides, tops, bottoms, shelves, and backs, making it more useful when you know the number and size of the cabinet boxes.

Yes. When cabinet backs are included, the estimator separates the material required for 3/4-inch structural cabinet components from the material required for 1/4-inch back panels. This more closely reflects how cabinet shops plan sheet orders.

The current height-based guidance uses two hinges for doors up to 40 inches, three hinges for doors over 40 inches through 60 inches, four hinges for doors over 60 inches through 80 inches, and five hinges for doors over 80 inches.

Always confirm the load rating and installation guidance provided by the hinge manufacturer.

Door height provides a useful baseline, but weight and width also matter. Heavy MDF doors, wide doors, glass inserts, and frequently used doors may require another hinge or a higher-capacity hinge even when height alone suggests fewer hinges.

The Kitchen Layout Planner helps organize a preliminary cabinet arrangement using room dimensions, cabinet placement, and project requirements. It can be used before the Cabinet Box Estimator or Sheet Calculator to establish a clearer project starting point.

The result is intended for preliminary planning and is not a final architectural, engineering, or fabrication drawing.

Use the Delivery Calculator after estimating your material quantity or order subtotal. It uses your delivery address, order subtotal, and driving time from the Berta Store New Jersey warehouse to provide a planning estimate.

If your location is not available or the delivery has special access requirements, contact Berta Store for a custom quote.

The calculator estimates sheet quantity, waste, and a basic cutting plan using standard cutting orientation. When grain direction or surface matching is important, manually review the layout and cut sequence before fabrication.

For many cabinet boxes, 3/4-inch plywood is the standard starting point because of its strength, stability, and screw-holding capacity. Shorter, lightly loaded shelves may work with 1/2-inch plywood, while longer spans or heavier loads commonly require 5/8-inch or 3/4-inch material.

The final choice depends on span, expected load, support, panel construction, joinery, and project requirements.

Enter the lengths and quantities of the exposed plywood or MDF edges that will receive edge banding. The calculator totals those measurements and converts them into an estimated linear-foot requirement.

Consider additional material for trimming, testing, splices, and installation waste.

The calculator uses your selected plywood types, thicknesses, and quantities to create estimated pallet configurations. It builds full pallets first and may combine remaining sheets into mixed pallets when possible.

The result shows the estimated number of pallets, pallet dimensions, weight, and how the order may be organized for shipping. Final freight dimensions and weights should be confirmed before shipment.

No. The calculators provide planning estimates based on the information entered. Final quantities may change because of cutting layout, grain direction, tolerances, panel defects, hardware specifications, installation conditions, or project revisions.

Review the result before ordering, cutting, or scheduling delivery.